Greentec Jaguar 40 drum chipper
100 – 200 hp
35 – 40 cm
2200 kg
Fitted as standard
- Top roller with combi infeed tablefor hand infeed and crane feed, hydraulic raisable
- Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream
Upper infeed roller internally driven by heavy, low maintenance Poclain engines, therefore no open slits besides the infeed, preventing chips from scattering
Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream.
red = powerfull airstream
blue = negative pressure / vacuum
yellow = woodchips
Knives are easy accessible, under a hinged cover, on the top of the machine.
Versions
- Top roller with bottom roller and combi infeed table for hand infeed and crane feed, hydraulic raisable
- Top roller with closed infeedchain covering complete width of the infeedtable
- Feed chain
Features |
| Woodchipper |
| Own hydraulic cooling system (using Venturi airflow) |
| Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream |
| No nonsense machine; chipping at the front, discharge at the back. |
| No jacks or accelarator needed, which otherwise shatters good woodchips. |
| This prevents unneccassary wear, saves power and therefore fuel, resulting in higher efficiency |
| Drum |
| (Quick-change) Knives distributed along the drum. Drum with blower blades on both sides. |
| Widia bottom knive placed below cutting knive, easy accessible |
| Exterior wall of drum is 20 mm thick and main axe Ø70 mm |
| Specially designed anvil knife, small branches are cut at a differente angle, resulting in better chipping quality. |
| Infeed |
| Upper infeed roller internally driven by heavy, low maintenance Poclain engines, therefore no open slits besides the infeed, preventing chips from scattering |
| Screenunit |
| Easy replacing of the screen at the side of the machine. Possible to chip without screen. |
| Quality |
| All machines are manufactured out of premium steel 355 (52-3) |
| Discharge chute, bottom between infeed roller and anvil knife beneath the drum equipped with replacable wear plate made of hardwearing Hardox steel |
| Machines are made of durable materials, including bearings, hydraulic valves, engines, pumps and more |
| After sandblasting machines are double powder coated |
| Servicing |
| Knives are easy accessible, under a hinged cover, on the top of the machine. |
| Drum is easily secured for changing knives. |
| Anvil knife adjustable, and can be used four times |
Technical Specifications | |
| Infeed opening (mm) | 400 x 600 |
| Feed opening channel (mm) | 420 x 600 |
| Max. infeed softwood (mm) | Ø 400 |
| Drum (mm) | Ø 600 x 600 |
| Top roller (mm) | Ø 430 |
| Chipper knives | 4 |
| Anvil knives | 1 |
| Max. chip length (mm) | 20 |
| Power requirements (HP) | 100 – 200 |
| Type C chute, hydraulic; slewing, up and down, deflector adjustment |
| Driveline PTO 1000 rpm GTJaguar 40D |
| Remote control (GCS1.1) for chipperfunctions Jaguar 40<br /> – Deflector adjustment<br /> – Chute rotation<br /> – Chute op/down<br /> – In/outfeed<br /> – Roll open or extra down pressure |
