Greentec Jaguar 40/12 back tipping
80 – 200 HP
40 cm
app. 7500 kg
20 mm
Fitted as standard
- Top roller with bottom roller and combi infeed table for hand infeed and crane feed, hydraulic raisable
- Top roller with closed infeedchain covering complete width of the infeedtable, only crane fed
- Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream
- LED-lighting
Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream
red = powerfull airstream
blue = under pressure/vacuum
yellow = snippers
Blades are easily accessible under hinged flap
Options
- Closed feed chain over the entire table length
- Different crane and crane control options
- Different lighting and support leg options chassis
- Action board
- Camera
- Winch
dense feed chain across the entire table length
Action board
Radio remote control for crane and chipper
Features |
| Woodchipper |
| Own hydraulic cooling system (using Venturi airflow) |
| Integrated blowing system which, in combination with Venturi blowing system guarantees a powerfull airstream |
| No nonsense machine; chipping at the front, discharge at the back. |
| No jacks or accelarator needed, which otherwise shatters good woodchips. |
| This prevents unneccassary wear, saves power and therefore fuel, resulting in higher efficiency |
| Drum |
| (Quick-change) Knives distributed along the drum. Drum with blower blades on both sides. |
| Widia bottom knive placed below cutting knive, easy accessible |
| Exterior wall of drum is 20 mm thick and main axe Ø70 mm |
| Specially designed anvil knife, small branches are cut at a differente angle, resulting in better chipping quality. |
| Infeed |
| Upper infeed roller internally driven by heavy, low maintenance Poclain engines, therefore no open slits besides the infeed, preventing chips from scattering |
| Screenunit |
| Easy replacing of the screen at the side of the machine. Possible to chip without screen. |
| Quality |
| All machines are manufactured out of premium steel 355 (52-3) |
| Discharge chute, bottom between infeed roller and anvil knife beneath the drum equipped with replacable wear plate made of hardwearing Hardox steel |
| Machines are made of durable materials, including bearings, hydraulic valves, engines, pumps and more |
| After sandblasting machines are double powder coated |
| Servicing |
| Knives are easy accessible, under a hinged cover, on the top of the machine. |
| Drum is easily secured for changing knives. |
| Anvil knife adjustable, and can be used four times |
Technical Specifications | |
| Infeed opening (mm) | 400 x 600 |
| Feed opening channel (mm) | 420 x 600 |
| Max. infeed softwood (mm) | Ø 400 |
| Drum (mm) | Ø 600 x 600 |
| Top roller (mm) | Ø 430 |
| Chipper knives | 4 |
| Anvil knives | 1 |
| Max. chip length (mm) | 20 |
| Power requirements (HP) | 80 – 200 |
| Version | Tandem, 4- wiel braked |
| Container Volume (m3) | 12 |
| Loading capacity tandem axle (tonnes) | 12 |
| Towbar height according to drawing |
| Built in tool storage 1100x650x900mm |
| Type C chute, hydraulic; slewing, up and down, deflector adjustment |
| Air brakes, 2 air ducts VC8 |
| LED-lighting around according to guidelines |
| Driveline PTO 1000 rpm GTJaguar 40 |
